February/2023 Latest Braindump2go 300-730 Exam Dumps with PDF and VCE Free Updated Today! Following are some new Braindump2go 300-730 Real Exam Questions!
Which feature allows the ASA to handle nonstandard applications and web resources so that they display correctly over a clientless SSL VPN connection?
A. single sign-on
B. Smart Tunnel
C. WebType ACL
Which command automatically initiates a smart tunnel when a user logs in to the WebVPN portal page?
Refer to the exhibit. Which two commands under the tunnel-group webvpn-attributes result in a Cisco AnyConnect user receiving the AnyConnect prompt in the exhibit? (Choose two.)
A. group-url https://172.16.31.10/General enable
B. group-policy General internal
C. authentication aaa
D. authentication certificate
E. group-alias General enable
Which two statements are true when designing a SSL VPN solution using Cisco AnyConnect? (Choose two.)
A. The VPN server must have a self-signed certificate.
B. A SSL group pre-shared key must be configured on the server.
C. Server side certificate is optional if using AAA for client authentication.
D. The VPN IP address pool can overlap with the rest of the LAN networks.
E. DTLS can be enabled for better performance.
An engineer is configuring IPsec VPN and wants to choose an authentication protocol that is reliable and supports ACK and sequence.
Which protocol accomplishes this goal?
Refer to the exhibit. What is the problem with the IKEv2 site-to-site VPN tunnel?
A. incorrect PSK
B. crypto access list mismatch
C. incorrect tunnel group
D. crypto policy mismatch
E. incorrect certificate
Which requirement is needed to use local authentication for Cisco AnyConnect Secure Mobility Clients that connect to a FlexVPN server?
A. use of certificates instead of username and password
C. EAP query-identity
D. AnyConnect profile
Which IKE identity does an IOS/IOS-XE headend expect to receive if an IPsec Cisco AnyConnect client uses default settings?
Refer to the exhibit. Which VPN technology is allowed for users connecting to the Employee tunnel group?
A. SSL AnyConnect
B. IKEv2 AnyConnect
C. crypto map
The tunnel-group Employee has no entry for a specific default-group-policy as with the Admin-Group.
The group-policy DfltGrpPolicy is used instead. This permits only ssl-clientless.
Refer to the exhibit. An engineer is troubleshooting a new GRE over IPsec tunnel.
The tunnel is established but the engineer cannot ping from spoke 1 to spoke 2.
Which type of traffic is being blocked?
A. ESP packets from spoke2 to spoke1
B. ISAKMP packets from spoke2 to spoke1
C. ESP packets from spoke1 to spoke2
D. ISAKMP packets from spoke1 to spoke2
Which command is used to troubleshoot an IPv6 FlexVPN spoke-to-hub connectivity failure?
A. show crypto ikev2 sa
B. show crypto isakmp sa
C. show crypto gkm
D. show crypto identity
In a FlexVPN deployment, the spokes successfully connect to the hub, but spoke-to-spoke tunnels do not form. Which troubleshooting step solves the issue?
A. Verify the spoke configuration to check if the NHRP redirect is enabled.
B. Verify that the spoke receives redirect messages and sends resolution requests.
C. Verify the hub configuration to check if the NHRP shortcut is enabled.
D. Verify that the tunnel interface is contained within a VRF.
An engineer is troubleshooting a new DMVPN setup on a Cisco IOS router. After the show crypto isakmp sa command is issued, a response is returned of “MM_NO_STATE.” Why does this failure occur?
A. The ISAKMP policy priority values are invalid.
B. ESP traffic is being dropped.
C. The Phase 1 policy does not match on both devices.
D. Tunnel protection is not applied to the DMVPN tunnel.
What are two variables for configuring clientless SSL VPN single sign-on? (Choose two.)
Which two NHRP functions are specific to DMVPN Phase 3 implementation? (Choose two.)
A. registration request
B. registration reply
C. resolution request
D. resolution reply
Refer to the exhibit. The customer can establish a Cisco AnyConnect connection without using an XML profile. When the host “ikev2” is selected in the AnyConnect drop down, the connection fails. What is the cause of this issue?
A. The HostName is incorrect.
B. The IP address is incorrect.
C. Primary protocol should be SSL.
D. UserGroup must match connection profile.
Refer to the exhibit. A site-to-site tunnel between two sites is not coming up.
Based on the debugs, what is the cause of this issue?
A. An authentication failure occurs on the remote peer.
B. A certificate fragmentation issue occurs between both sides.
C. UDP 4500 traffic from the peer does not reach the router.
D. An authentication failure occurs on the router.
Refer to the exhibit. Based on the debug output, which type of mismatch is preventing the VPN from coming up?
A. interesting traffic
C. preshared key
The IPsec SA setup has failed due to a mismatch in the policy rule definition between the gateways for the tunnel configuration.
Check the local and remote network configuration on both gateways.
Refer to the exhibit. The IKEv2 site-to-site VPN tunnel between two routers is down. Based on the debug output, which type of mismatch is the problem?
A. preshared key
B. peer identity
C. transform set
D. ikev2 proposal
Refer to the exhibit. Which type of mismatch is causing the problem with the IPsec VPN tunnel?
A. crypto access list
B. Phase 1 policy
C. transform set
D. preshared key
Refer to the exhibit. What is a result of this configuration?
A. Spoke 1 fails the authentication because the authentication methods are incorrect.
B. Spoke 2 passes the authentication to the hub and successfully proceeds to phase 2.
C. Spoke 2 fails the authentication because the remote authentication method is incorrect.
D. Spoke 1 passes the authentication to the hub and successfully proceeds to phase 2.
Which two cryptographic technologies are recommended for use with FlexVPN? (Choose two.)
A. SHA (HMAC variant)
D. MD5 (HMAC variant)
Refer to the exhibit. An administrator had the above configuration working with SSL protocol, but as soon as the administrator specified IPsec as the primary protocol, the Cisco AnyConnect client was not able to connect. What is the problem?
A. IPsec will not work in conjunction with a group URL.
B. The Cisco AnyConnect implementation does not allow the two group URLs to be the same.
SSL does allow this.
C. If you specify the primary protocol as IPsec, the User Group must be the exact name of the connection profile (tunnel group).
D. A new XML profile should be created instead of modifying the existing profile, so that the clients force the update.
Refer to the exhibit. Client 1 cannot communicate with client 2. Both clients are using Cisco AnyConnect and have established a successful SSL VPN connection to the hub ASA.
Which command on the ASA is missing?
A. dns-server value 10.1.1.2
B. same-security-traffic permit intra-interface
C. same-security-traffic permit inter-interface
D. dns-server value 10.1.1.3
Refer to the exhibit. An SSL client is connecting to an ASA headend. The session fails with the message “Connection attempt has timed out. Please verify Internet connectivity.” Based on how the packet is processed, which phase is causing the failure?
A. phase 9: rpf-check
B. phase 5: NAT
C. phase 4: ACCESS-LIST
D. phase 3: UN-NAT
Which redundancy protocol must be implemented for IPsec stateless failover to work?
Which technology works with IPsec stateful failover?
What are two functions of ECDH and ECDSA? (Choose two.)
C. digital signature
D. key exchange
What uses an Elliptic Curve key exchange algorithm?
Which two remote access VPN solutions support SSL? (Choose two.)
E. Cisco AnyConnect
1.2023 Latest Braindump2go 300-730 Exam Dumps (PDF & VCE) Free Share:
2.2023 Latest Braindump2go 300-730 PDF and 300-730 VCE Dumps Free Share:
Free Resources from Braindump2go,We Devoted to Helping You 100% Pass All Exams!
|One Time Purchase||✔||✖||✖||✖||✖|
|100% Pass Guarantee||✔||✖||✖||✖||✖|
|100% Money Back||✔||✖||✖||✖||✖|